Amana Washer and Dryer

Amana Washer Makes Loud Noise When Spinning?- 10 Easy Solutions!

Amana Washer Makes Loud Noise When Spinning
( Disclaimer: As an Amazon Associate, we earn commissions from qualifying purchases at NO additional cost to the customer.)                                          

Amana was founded in 1922 and has grown into one of America’s largest appliance manufacturers.

The company offers top-of-the-line washers, dryers, refrigerators, stoves, microwaves, dishwashers, ovens, ranges, cooktops, and water heaters.

In addition to selling its own brand name products, the company trades under various other brands such as Whirlpool, Maytag, KitchenAid, Jenn Air, Kenmore, Frigidaire, Sears, and Electrolux.

Amana washers are known for being quiet and efficient.

They also come with a built-in water filtration system.

This means they don’t require filters or chemicals to clean clothes.

However, some consumers report that their Amanas make a loud noise when spinning.

If you are experiencing an unusual sound coming from your washing machine when its spinning, check for water leaks or clogged drains.

The other reasons are unbalanced agitator, too much lint, worn out agitator.

A noisy washer also could be caused by a worn out belt, broken pump, or loose parts inside the machine.

Check out our guide below to see if there’s something wrong with your machine.

 Causes And Fixes – Amana Washer is Makes Loud Noise When Spinning

The agitator is not properly balanced on its shaft

If the agitator is not balanced correctly on the shaft, it can make noise while washing/spinning the clothes.

This is because the agitator is moving around inside the tub, causing friction against the tub’s sides.

How to Fix

To balance the agitator, first, check if there are any loose parts or broken pieces of the agitator.

Then, take out the agitator and place it on a flat surface.

Next, remove all the screws holding the agitator together.

Now, look at the bottom of the agitator and see how many holes are present.

There should be one hole near the center and another hole towards each side of the agitator’s base.

These holes help to keep the agitator balanced. After this, screw the agitator back together.

The agitator has been damaged by being dropped, creating loud noise

Amana Washer makes loud noise when spinning  due to damaged agitator.

The agitator is the rotating drum inside the machine that helps move water through the wash cycle.

If the motor or other parts of the agitator are damaged due to being dropped, then the machine may be noisy.

It can also cause damage if the agitator is broken off or missing, then the machine won’t be able to function properly.

It’s possible to replace the agitator yourself, but it can be tricky if you don’t know how to remove the old one first.

How to fix

If you drop the agitator of the Amana washer while washing clothes, you should immediately stop using the Amana machine until the problem is fixed.

This could cause damage to the motor and other parts of the machine.

To prevent further damage, turn off the power supply to the machine and remove all clothing from the drum.

Then, contact the manufacturer for assistance.

You could try this DIY step yourself, the motor housing is held together with two screws on each side.

Remove these screws and remove the motor housing from the machine.

Replace the motor housing if necessary.

If there is no visible damage to it, replace the agitator assembly.

Too much lint in washer

If there are too many lint balls in the washing machine, they can cause noise.

This problem occurs because the lint balls get stuck between the agitator and the drum, making them vibrate against each other.

To fix this issue, you should remove any lint balls from the inside of the machine by hand or with a brush before running the wash cycle.

How to fix

One way to rectify this is to clean the lint from the inside out.

Remove all clothes from the machine and then remove the top cover.

Next, use a brush to gently sweep away debris from the machine’s bottom.

Finally, spray some water into the machine through the drain hole.

This should help to clear up the clogged area.

If this doesn’t work, contact our customer service team for assistance.

Agitator does not have enough contact with the clothes

Amana washer agitators are designed to be placed inside the drum of the washing machine so they can agitate the clothing during the wash cycle.

They also help keep the laundry clean by removing lint and other debris from the clothing.

However, if there isn’t enough space between the washer agitator and the clothes, then the clothes won’t get agitated properly.

This could cause damage to the clothes or even lead to them being ruined.

It has been found that some models of Amana washer agitating machine does not have sufficient contact with the clothes. This results in uneven washing of the clothes.

How to fix

If you are searching for a way to reduce noise while washing clothes, there are several options available.

One option is to install a washer agitator that has more surface area to make sure that the clothes get agitated properly.

Another option is to add a second agitator to the machine.

This can be done by purchasing a separate agitator or by installing one inside the existing agitator.

The agitator may be worn out

If you have a washing machine with a built-in agitator, it’s possible that the motor has failed and needs replacing.

This sort of thing can happen if the motor gets too hot or if there are problems with the bearings.

It could also mean that the agitator itself is worn-out.

A worn-out washer agitator can cause loud noises during operation.

If this occurs, the machine should be stopped immediately and checked by a service technician.

This problem can also occur if the machine has been left unused for a long time or if there are too many clothes in the drum.

How to fix

If you have a broken agitator, then you should replace agitator immediately.

This part is easy to find, just go to any local hardware store or online store.

However, if you don’t know where to look, then you can contact a professional appliance repairman who has experience fixing washing machines.

The agitator is not connected to the motor

This means that the agitator is disconnected from the motor.

If you notice that the agitator isn’t turning, then you need to reconnect it to the motor.

You will find information on how to do this on the manual that came with your washer.

The Amana washer washes clothes too fast causing noise

Washing machines can indeed be noisy.

But if you are out searching for a quiet machine, there are some things you should know about how they work.

The speed of the washer determines how long it takes to complete the wash cycle.

If you set the washer to do a quick wash cycle, then it will take less time and cause more noise than if you set it to run a normal wash cycle.

But, if you’re using a lot of detergent, then you might want to use a slow wash cycle instead.

How to fix

First, the sound isn’t coming from the motor itself; rather, it’s caused by vibrations that travel through the machine.

This means that the louder the spin cycle gets, the more likely it is that the noise will get worse.

If you want a quieter machine, look for one with less vibration or choose a model that has a variable speed control instead of a constant-speed setting.

 Common Solutions -Amana Washer is Making Loud Noise When Spinning

A washer agitator is an internal component inside a washing machine that spins around during operation.

It is designed to help remove lint from clothes and prevent them from becoming tangled or damaged.

If you hear loud noises coming out from your washer, this could be caused by an agitator problem.

The most common reason for a washer to make loud noises is because of an issue with the agitator.

If you are experiencing an unusual sound coming from your washing machine, check for water leaks or clogged drains.

A noisy washer could be caused by a worn out belt, broken pump, or loose parts inside the machine.

Amana washer pump

A washer pump is an electric motor used to move water through clothes dryers or washing machines.

It may be noisy when you turn on the machine for the first time after being idle for several hours.

If this happens, wait until the unit warms up before using it again.

Have you replaced the belt?

A washer belt pulley will make a loud grinding or clanking sound when you put tension on it.

It may also be making a squeaking sound.

If this happens, take off the cover plate from the back side of the engine and remove the belt.

Then tighten the belt with the new washer belt pulley.

Replace the cover plate and tighten the bolts.

Is the drain hose clogged?

Drain hoses are designed to be flexible so they will move with the flow of water.

If you hear a loud hissing sound when running water, this means there is air trapped inside the pipe or the valve is stuck open.

To fix this problem, turn off the faucet and remove the aerator from the end of the pipe.

Then find a used old toothbrush to clean out any debris that may be blocking the opening.

After cleaning, replace the aerator and turn on the tap again.

 

Related Articles:

Amana Washer Lid Lock Light Flashing?

Amana Washer Makes Noise When Filling?

Amana Washer Agitator Loose?

Amana Washer Makes Screeching Noise?

Amana Washer Stuck On Final Spin?